Balboa 20

The Balboa 20 is an American trailerable sailboat that was designed by Lyle C. Hess as a cruiser, at the request of Richard Arthur and first built in 1967.

The success of the Balboa 20 allowed Hess to become a sailboat designer on a full-time basis.

The Balboa 20 hull design was used for two 1972 raised deck boats, the Ensenada 20 and the RK 20.

Production
The design was built by Arthur Marine and Coastal Recreation, Inc in the United States, starting in 1967, but it is now out of production.

Design
The design goals for the boat were low cost and good seaworthiness.

The Balboa 20 is a recreational keelboat, built predominantly of fiberglass, with wood trim. It has a fractional sloop rig, a spooned raked stem, an angled transom, with a lazarette, a transom-hung rudder controlled by a tiller and a lifting keel. It displaces 1700 lb and carries 450 lb of cast iron ballast.

The boat has a draft of 4.42 ft with the keel extended and 1.58 ft with it retracted, allowing beaching or ground transportation on a trailer.

The boat is normally fitted with a small 3 to 6 hp outboard motor for docking and maneuvering.

The design has sleeping accommodation for four people, with a double "V"-berth in the bow cabin and two quarter berths in the main cabin. The galley is located on the starboard side just forward of the companionway ladder. The head is located under the bow cabin berth. Cabin headroom is 48 in.

The design has a PHRF racing average handicap of 276 and a hull speed of 5.6 kn.

Operational history
In 1977 it was reported that the designer's personal boat was a Balboa 20, named Genesis.

In a 2010 review Steve Henkel wrote, "Lyle Hess’s designs are usually thought to be prettier (or handsomer?) than most, but in this early design it is hard to see a clear distinction from many other trailer-sailers of the era. Worst features: The cast iron swing keel, weighing more than a quarter of the total boat and controlled by a winch in the cabin, is at best a maintenance headache and at worst could cause serious leakage in the hull due to strain."