Bridgman–Stockbarger method

The Bridgman–Stockbarger method, or Bridgman–Stockbarger technique, is named after physicist Percy Williams Bridgman (1882–1961) and physicist Donald C. Stockbarger (1895–1952). The method includes two similar but distinct techniques primarily used for growing boules (single-crystal ingots), but which can be used for solidifying polycrystalline ingots as well.

Overview
The methods involve heating polycrystalline material above its melting point and slowly cooling it from one end of its container, where a seed crystal is located. A single crystal of the same crystallographic orientation as the seed material is grown on the seed and is progressively formed along the length of the container. The process can be carried out in a horizontal or vertical orientation, and usually involves a rotating crucible/ampoule to stir the melt.

The Bridgman method is a popular way of producing certain semiconductor crystals such as gallium arsenide, for which the Czochralski method is more difficult. The process can reliably produce single-crystal ingots, but does not necessarily result in uniform properties through the crystal.



The difference between the Bridgman technique and Stockbarger technique is subtle: While both methods utilize a temperature gradient and a moving crucible, the Bridgman technique utilizes the relatively uncontrolled gradient produced at the exit of the furnace; the Stockbarger technique introduces a baffle, or shelf, separating two coupled furnaces with temperatures above and below the freezing point. Stockbarger's modification of the Bridgman technique allows for better control over the temperature gradient at the melt/crystal interface.

When seed crystals are not employed as described above, polycrystalline ingots can be produced from a feedstock consisting of rods, chunks, or any irregularly shaped pieces once they are melted and allowed to re-solidify. The resultant microstructure of the ingots so obtained are characteristic of directionally solidified metals and alloys with their aligned grains.

Bagdasarov method
A variant of the technique known as the horizontal directional solidification method (HDSM) developed by Khachik Bagdasarov (Хачик Багдасаров) starting in the 1960s in the Soviet Union. It uses a flat-bottomed crucible made out of molybdenum with short sidewalls rather than an enclosed ampoule, and has been used to grow various large oxide crystals including Yb:YAG (a laser host crystal), and sapphire crystals 45 cm wide and over 1 meter long. The quality of the crystals grown by HDSM differs from ones grown by the Czochralski method.