Natural Bridges National Monument Solar Power System

Natural Bridges National Monument Solar Power System is an experimental electrical power plant at the Natural Bridges National Monument in the southeastern portion of the U.S. state of Utah. It consists of 256,812 solar cells arranged in 12 rows, each measuring 200 ft long. Direct current energy from the array is converted to alternating current at an equipment building, then supplied to the park's staff buildings and visitor center. Excess energy is stored in a bank of batteries that is used on cloudy days. The system is controlled by computers and creates fewer emissions than the diesel generators that it replaced.

When it was dedicated in June 1980 by the Utah Governor, it was the world's largest solar plant at 100 kW. The solar power station was later downsized to 50 kW and supplemented with a diesel generator backup system which allowed the solar array to operate more efficiently.

History
The electrical power plant, located in Natural Bridges National Monument, is a joint experimental venture between the Massachusetts Institute of Technology's Lincoln Laboratory and the United States National Park System and Department of Energy. It was initiated in 1979 and when dedicated in June 1980 by the Utah Governor, it was the world's first solar-power generating system. It is 6500 ft above sea level and located in a desert in the southeast corner of the U.S. state of Utah. An array of solar panels are set up and located on 1.3 acre adjacent to the park's visitor center. The visitor center has an observation platform nearby overlooking the solar cells and recorded narration explaining the function of the facility. Natural Bridges receives sunlight year-round and is far from other commercial power sources, making it an ideal site for an experimental solar cell power system.

The 1980 project cost $15 million ($0 in 2022 dollars) and a power plant 30 years later would cost about $1.5 million ($0 in 2022 dollars) because of technical advances in solar cell production. The power plant operated for 10 years before it was shut down for overhaul and upgrading. The plant was downsized from 100 kW to 50 kW and supplemented with a diesel generator backup system which allowed the solar array to operate more efficiently. At this time the modernization involved adding 18 kW of new state-of-the-art solar modules, replacing the battery bank and upgrading the wiring to a higher gauge. The electric power system was again renovated in 2003 with new 319 kilowatt lead-acid rechargeable batteries and 100 kilowatt electronic DC to AC inverters.

Characteristics
The photovoltaic system (PV) plant is 40 mi from the nearest power line. It originally consisted of 256,812 individual solar cells with diameters of 2 in and 3 in, arranged in 12 rows; these were originally capable of 100 kW at noon with full sunlight. The direct current (DC) power generated by the solar cells is converted to alternating current (AC) power. AC electricity is used for the visitors' center, six staff residences, maintenance facilities, and the local water sanitation system. The system is protected with lightning rods.

When the array started operating, it contained 39 rechargeable lead-acid batteries, each weighing 1200 lb, with a combined capacity of 600 kWh. This provides enough power for the park to operate for two cloudy days, when it typically uses 450 kWh. There are two 40 kW diesel generators as well. When the batteries are nearly fully charged, the array's control system can disconnect some of the 48 array stations.

The PV system saves $30,000 annually compared to diesel generators that provide the same amount of energy; in addition, the arrays are quieter and produce less air pollution than diesel generators. Furthermore, the PV plant reduces annual emissions by 400 lb of sulfur oxides, 2100 lb of nitrogen oxides, 170 ST of carbon dioxide, and 250 lb of carbon monoxide.

Photovoltaic equipment
The array consisted of 12 rows of panels. Each row is approximately 200 ft long and has 48 2 kW solar cells. The 576 solar panels have a total area of 10,645 sqft. They replaced a set of 40-kilowatt diesel generators, which used 1500 U.S.gal of diesel fuel each month. The costly diesel fuel had to be trucked to the Park facilities and came from 100 mi to 130 mi away. The network of rows of panels required 288 piers to support them. Each pier is 18 in in diameter and ranged in depth from 1 ft to 6 ft depending on the engineer's assessment of the load and the depth of the subsurface rock. The surveying for the location of each of the piers began August 1, 1979.

The solar panel array field is composed of ninety-six steel frames. Each measure 8 ft by 24 ft and weigh 1500 lb. These frames have twelve additional frames mounted within them. There are a total of 1152 sub-frame assemblies. These frame components were assembled off-site and shipped to the site as needed for the construction schedule. The Lincoln Laboratory of the Massachusetts Institute of Technology had hired Ford, Bacon, and Davis Incorporated of Salt Lake City as their main contractors for all the design work and installation of the steel frames for the array field of solar panels.

Photovoltaic equipment building
The photovoltaic equipment building of 1980 is divided into three rooms. One room is for the battery subsystem that contained the large heavy duty batteries. Another room is for the power distribution equipment. The third room had the computer control systems and work space. The photovoltaic equipment building is designed and constructed by the National Park Service contractors under management of MIT Lincoln Laboratory. The batteries, inverters, and chargers were first tested at MIT and then shipped to the site. The batteries had a storage capacity of 600 kWh. Power wires were run to a building of diesel generators as a back-up. Electric meters were installed to measure the building power consumption and energy used by the complete site.

The building design had energy saving techniques that did not allow the sun to penetrate it. The construction included triple-glazed windows, fully insulated exterior walls, placement of windows away from direct sun, and thermal shutters. A built in safety feature is a blow-out panel in case of a battery explosion so that debris objects would go away from employees. The internal walls of the room housing the electrical equipment, which included the inverter and battery charger, were covered with sound-proofing material. The room had a black painted gypsum board covering on the concrete walls and is covered with a vinyl siding. There were eye wash stations made and a lightning grid protection system. The exterior walls were covered with standard sheets of plywood and then covered with cedar siding to follow the park architecture. There were fans and air-conditioners installed. The floors were covered with a vinyl asbestos tile.