Talk:Extruder (3D printing)

Unnamed section
In the disadvantages it states that Bowden extruders push rather than pull the filament. Although this is true, this is also true for all extruders, including direct drive. The only difference is the length of the path between the extruder and hot end. — Preceding unsigned comment added by 69.5.141.129 (talk) 2018-05-18T00:03:07 (UTC)

"Direct extrusion" also links to here
There is a link to "direct drive extruders" in this article that links to the Bowden extrudar article itself. — Preceding unsigned comment added by 158.42.231.67 (talk) 18:36, 26 February 2021 (UTC)

Requested move 11 May 2021

 * The following is a closed discussion of a requested move. Please do not modify it. Subsequent comments should be made in a new section on the talk page. Editors desiring to contest the closing decision should consider a move review after discussing it on the closer's talk page. No further edits should be made to this discussion. 

The result of the move request was: moved. (closed by non-admin page mover) ~ Aseleste  (t, e &#124; c, l) 00:35, 19 May 2021 (UTC)

Bowden extruder → 3D printer extruder – The article currently discusses pros and cons of two different types of 3D printer extruders, namely the Bowden extruder and the direct drive extruder. It seems more appropriate to have an article name which corresponds with mentioning and comparing different types of extruders in general. Alternatively, the content may be merged into Fused filament fabrication. Sauer202 (talk) 20:08, 11 May 2021 (UTC) The discussion above is closed. Please do not modify it. Subsequent comments should be made on the appropriate discussion page. No further edits should be made to this discussion.
 * Support. Rreagan007 (talk) 18:43, 16 May 2021 (UTC)