Talk:MEMS electrothermal actuator

A good source for these would be Rostra Vernatherm, manufacturer of these types of products for over 75 years; located in Bristol, CT USA. http://www.vernatherm.com

MEMS electrothermal actuator
I am rewriting this article in a detailed way and I think the most suitable title is "MEMS electrothermal actuator". Muhammadrehan645 (talk) 13:21, 9 July 2024 (UTC)

It would be better to give a simple introduction about the basic principle of this kind of device. Besides, it would be more objective to give a complex comparision between this kind of actuator and the other types instead of solely discussing the advantages.--ChenLZ.1997 (talk) 13:15, 12 July 2024 (UTC)


 * Thanks for the valuable comment I will try to make the suggested changes Thanks. Muhammadrehan645 (talk) 13:47, 12 July 2024 (UTC)

Review n. 2
The article is very detailed and technical. I made some minor corrections to fix the gramamr and some typos. Good job! --Paneappenasfornato (talk) 13:54, 12 July 2024 (UTC)


 * Thanks Muhammadrehan645 (talk) 14:09, 12 July 2024 (UTC)

Review
The article is well written and full of details. Please, fix the list of types since there must have been some change wile writing the article:
 * In the introduction of the article they are hot and cold arm, bimorph designs and chevron
 * In the introduction of the paragraph on types they are Asymmetric also known as hot and cold arm, Symmetric also known as chevron, bimorph
 * The sub-paraghraph are Asymmetric (bimorph, U-Shaped), Symmetric (bent beam, chevron), Bimorph

It can be easier for the reader if the name are used more consistently and in the same order. Also, it can be confusing that the Bimorph is both in the asymmetric and in a distinct sub-paragraph.

A part from the minor adjustment, the article is great, thank you for your contribution! Thomas Dalberto (talk) 14:01, 12 July 2024 (UTC)


 * Thanks for pointing out the mistake, I have updated it. Muhammadrehan645 (talk) 14:17, 12 July 2024 (UTC)