Tupolev ANT-3

The ANT-3 was a Soviet all-metal aircraft designed by the Tupolev Design Bureau. Tupolev acquired much experience in building his first two aircraft, later using his experience to construct the ANT-3. By this time, Soviet Air Force leaders were convinced that metal was a highly usable substance in the building of airplanes. Tupolev therefore guided AGOS- TsAGI in creating the first Soviet all-metal aircraft. The ANT-3 was Tupolev's first practical aircraft.

Construction and Development
On 1 August 1924, design work started for the ANT-3, by the following July the prototype was completed at the AGOS factory. The sesquiplane ANT-3 first flew on 6 August 1925, piloted by V. N. Fillipov, a TsAGI test-pilot. The VVS (Voenno-Vozdushnye Sily - military air forces) ordered several ANT-3s, designated R-3 (R - Razvedchik - reconnaissance), after successful flight tests led by Mikhail Gromov. However, production was limited by the shortage of raw materials, but those that were produced proved useful for propaganda purposes.

Production
The ANT-3 was produced between 1926 and 1928 at GAZ-5 (GAZ - Gosudarstvenny Aviatsionnyy Zavod – state aviation plant/factory) in Moscow and, from late 1928, at GAZ-22. 102 units were probably produced in total.

Design
The ANT-3 was a sesquiplane seating two in tandem cockpits, with the pilot in front and gunner behind. The structure was predominantly built from light alloys with corrugated kol'choogaluminly skin. Lower main-planes were attached to the lower fuselage, whilst the upper mainplane was supported on short cabane struts. Wire bracing and streamlined 'V' interplane struts provided structural integrity.

The single-engined ANT-3 could be powered by a range of engines from 300 - 500 kW; the prototype used a 298 kW Liberty, the second aircraft was powered by a 336 kW Napier Lion; the first 79 production aircraft used the 336 kW Lorraine-Dietrich 12E; 21 aircraft used the 336 kW Mikulin M-5 and one used a 373 kW BMW VI.

Tupolev proposed an upgraded version, to be powered by a 373 kW Mikulin engine, with a range of about 966 km. One was built with a Lorraine-Dietrich engine, delivered to Aeroflot's Yakutsk division, designated PS-3 and used as a mail-plane until about 1930.

Operational history
The R-3, used by the military for reconnaissance, was also used for propaganda purposes with long-distance flights.

In the summer of 1926 the prototype R-3NL, named Proletariy (En:proletarian) and registered RR-SOV, piloted by Mikhail Gromov, assisted by mechanic Yevgeny Radzevich, flew a round Europe flight: Moscow - Königsberg - Berlin - Paris - Rome - Vienna - Prague - Warsaw - Moscow; After flying for about 120 km, a coolant expansion tank suffered fatigue failures, spraying water around the cockpit. Gromov returned to Moscow and newspapers stated that he and Radzevich turned back due to poor weather. The incident caused Tupolev to recommend that the tank have a convex base, which was adopted. Gromov resumed his expedition landing at Königsberg, by which point the radiator was leaking. Gromov proceeded to Berlin where mechanics were unable to repair the radiator. Moving on, they flew on to Paris, where a mechanic found that some putty sealant had separated. To solve the problem, he took another aircraft's radiator, adapting it to fit in the ANT-3, after which Gromov and Radzevich flew off to Rome. Later Gromov and Radzevich flew north to Vienna, but the sun started to set and it was dark when they were just 19 km from Vienna. Gromov decided to risk landing in Vienna, where campfires were lit around the airport to illuminate the landing strip. The remainder of the flight was largely uneventful other than overflying Prague to continue to Warsaw. By their return to Moscow they had flown a distance of 7150 km in 34 hours 15 minutes flying time at an average speed of 210 km/h, for a new national long-distance speed record.

The second production ANT-3M-5, registered RR-INT and named Nash Otvet (En:Our Answer), was flown by S.A. Shestakov and D.F Fufayev from Moscow to Tokyo and return, via Sarapul, Omsk, Novosibirsk, Krasnoyarsk, Irkutsk, Verkhneudinsk, Chita, Nerchinsk, Blagoveshchensk, Spassk, Nanyuan and Yokohama, taking 12 days, covering 22000 km in 153 hours flying time. The flight was titled "The Great Eastern Overflight"

Variants

 * ANT-3
 * Prototype, powered by a 298 kW Liberty L-8 engine.


 * R-3
 * Original production military reconnaissance aircraft powered by Mikulin M-5 engines; 21 built.


 * R-3LD
 * 79 production aircraft fitted with 336 kW Lorraine-Dietrich 12Eb engines.


 * R-3NL
 * Second prototype, powered by a 336 kW Napier Lion engine; RR-SOV Proletariy (Proletarian).


 * R-7
 * Improved derivative of the R-3, powered by a 373 kW BMW VI engine. A single prototype was built, also known as the ANT-10.


 * PS-3
 * Designation for 30 R-3s that were modified into mailplanes for service with Aeroflot.

Operators

 * Soviet Union
 * Soviet Air Force