User:Amk1251908/sandbox

added new section "other programs" to hearing conservation program

Other Regulatory Agencies
The Mine Safety and Health Administration (MSHA) requires that all feasible engineering and administrative controls be employed to reduce miners' exposure levels to 90 dBA TWA. The action level for enrollment in a hearing conservation program is 85 dBA 8-hour TWA, integrating all sound levels between 80 dBA to at least 130 dBA. MSHA uses a 5-dB exchange rate (the sound level in decibels that would result in halving [if an increase in sound level] or a doubling [if a decrease.in sound level] the allowable exposure time to maintain the same noise dose). At and above exposure levels of 90 dBA TWA, the miner must wear hearing protection. At and above exposure levels above 105 dBA TWA, the miner must wear dual hearing protection. Miners may not be exposed to sounds exceeding 115 dBA with or without hearing protection devices. MSHA defines a standard threshold shift as an average decrease in auditory sensitivity of 10 dB HL at the frequencies 2,000, 3,000, and 4,000 Hz. (30 CFR Part 62 ).

The Federal Railroad Administration (FRA) encourages, but does not require, railroads to use administrative controls that reduce noise exposure duration when the worker exceeds 90 dBA TWA. The FRA defines the action level for employee enrollment in a hearing conservation program as an 8-hour TWA of 85 dBA on certain railroads, integrating all sound levels between 80 dBA and 140 dBA. FRA uses a 5-dB exchange rate. Those employees who are always at or above 90 dBA TWA are required to wear hearing protection such that sound levels are attenuated below 90 dBA TWA. (49 CFR Part 229 ).

The U.S. Department of Defense (DOD) specifies that engineering controls are preferential when reducing the noise levels at the source. The use of hearing protective devices is considered an "interim protective measure" while engineering controls are developed. The goal of these controls is to reduce ambient steady-state noise levels to 85 dBA regardless of TWA exposure and to reduce impulse noise levels to below 140 dBP. The DOD requires that personnel be entered into a hearing conservation program when continuous snd intermittent noise levels ale grs greater than or equal to 85 dBA TWA, when impulse SPL are at or in excess of 140 dBP, or when the personnel is exposed to ultrasonic frequencies. The DOD integrates all sound levels between 80 dBA to a minimum of 130 dBA when determining an individual or representative noise dose. When used, hearing protectors must be capable of attenuating worker noise exposure below 85 dBA TWA. Hearing protection is required to be carried by personnel who work in designated noise areas, such as those exposed to gunfire or ordnance tests and Service musicians. The DOD defines a significant threshold shift as a 10 dB average decrease in hearing thresholds at 2,000, 3,000, and 4,000 Hz in either ear, with no age corrections. It is further specified that a shift in 15 dB at 1,000, 2,000, 3,000, or 4,000 Hz is an early warning sign for an STS; follow-up retraining is required in this case. (DOD Instruction 6055.12 ).

The European Union (EU) requires a hearing conservation program be implemented when the worker exposure levels exceed 80 dBA TWA. Note that this is more strict than hearing conservation regulations in the United States. The EU specifies several different exposure action values: a "lower" value of 80 dBA at which the employer must make hearing protection devices available to the employee; an "upper" value of 85 dBA at which the employee is required to wear hearing protection; and an "exposure limit" value of 87 dBA, under which the individual's noise exposure shall be limited to preserve hearing. The directive also defines a weekly noise exposure level which is applied to individuals working in circumstances of inconstant noise exposure. Finally, the EU also recommends a variety of noise reduction methods, including administrative controls to reduce worker exposure duration, the provision of quieter equipment, and adequate maintenance of machinery and other noise sources (European Parliament and Council Directive 2003|10|EC ).