User:Bernasma/sodium ion battery

Sodium-ion batteries are a type of reusable battery that uses sodium-ions as a way to store power in a compact system. This type of battery is still in a developmental phase but is forecasted to be a cheaper, more durable way to store energy than commonly used lithium-ion batteries. Unlike sodium-sulfur batteries, sodium ion batteries can be made portable and are able to work at room temperature (approx. 25˚C).

Energy Storage
Sodium ion batteries store energy in chemical bonds in it cathode. When the battery is charging Na+ ions intercolate or migrate towards the interior of the battery where the cathode is. Meanwhile charge balancing electrons pass from the cathode through the internal circuit of the charger and into the anode of the battery. During discharge the same process occurs but in the opposite direction. Once a circuit is completed electrons to pass back from the anode to the cathode and the Na+ ions travel back to anode.

Benefits
Currently lithium-ion batteries are the preferred portable battery for most electronic devices and hybrid cars. Unfortunately, lithium is in short supply, where as sodium is much more abundant. If the modern day batteries were switched over to a sodium-ion cell it would greatly lower the price of the product. Researchers like Jay Whitacre, at Carnegie Mellon University, say that the sodium cell would also be able to store more energy which would make it a better option for storing reusable energy at solar and wind farms.

Research
A normal sodium cell voltage is 3.6 volts and is able to mantain 115 mA·hr g-1 after 50 cycles. Which means the battery approximately has a storage capacity of 400 W·hr kg-1 Yet, sodium-ion batteries are still unable to maintain a strong charge after repeated charge and discharge. After 50 cycles most sodium-ion batteries tend to store about 50% of original capacity. Researchers are now looking at different anode and cathode materials that will allow a sodium cell to maintain its original charge.

Na/NaxC6
In 1999, D.A. Stevens and J.R. Dahn were the first to test a new anode material made of carbons, (NaxC6). They fount the average voltage on the low potential platau was higher on the Na cells compared to the Li cells. They also showed a glucose precursor can be used to make carbon meterials with a high reversable capacity.

NaV1−xCrxPO4F
This type of sodium-ion battery was tested by Haitao Zhuoa, Xianyou Wanga, Anping Tanga, Zhiming Liua, Sergio Gamboab and P.J. Sebastianb. They found that through the reaction:

NaF + (1−x)VPO4 + xCrPO4 → NaV1−xCrxPO4F

the introduction of the Cr helped the battery retain more energy through cycles of charge and discharge. The chart below (from their study) shows the differences between the the battery with and without Cr.

Na2FePO4F
In 2007 researchers B. L. Ellis, W. R. M. Makahnouk, Y. Makimura, K. Toghill, and L. F. Nazar tested Na2FePO4F and Li2FePO4F cathode materials in rechargeable batteries along with a mixture of the two cathode materials. They found the sodium iron phosphate cathode easily replaces a lithium iron phosphate in a Li cell. The combined lithium-ion and sodium-ion make up would lower the overall price of the battery.