User:Devildogatl/cop

DETERMINING IF TRUNKS ARE IN USE
Log in to the switch- >root >yam >mant >wat >cct=THE CARD OF THE T-1 YOU ARE TRUNKING ACROSS.

THIS WILL BRING UP ALL 24 CIRCUTS THAT ARE ON THE T-1. THE MAX WE WILL HAVE WORKING IS 12.

THE MESSAGE WILL BE:	2. CCT=1/1/2 CALL: state: trunk idle. IF THE TRUNK IS NOT IN USE.

THE MESSAGE WILL BE:	0. CCT=1/1/0 CALL: state: hold (t-l) outgoing IF THE A TRUNK IS RINGING A FOREIGN SWITCH.

THE MESSAGE WILL BE:	0. CCT=1/1/0 CALL: state: TALKING (t-l) outgoing IF THE TRUNK IS CURRENTLY IN USE.

This will be used if a subscriber is asking you why he can’t dial out of the switch. Follow the procedures above. If you have trunks that are IDLE, then dial out to BRKS 1210 from our ste to verify the trunk is up.

CHANGING A SUBSCRIBER PHONE NUMBER
Identify the phone number the subscriber currently has. Look at the duct tape diagram to determine which circuit the phone number is on. Log into the switch >root >yam >adm >msu= IF THE PHONE IS ON THE LEFT OF THE DUCT TAPE DIAGRAM, THEN THE MSU NUMBER WILL BE MSU=1/0. IF THE PHONE IS ON THE RIGHT OF THE DUCT TAPE DIAGRAM, THEN THE MSU NUMBER WILL BE MSU=2/0.

Cct=	MSU/0.CARD/CIRCUT. For cct, you want to enter the card/circuit of the phone number that is located on the duct tape diagram. >cir >The current station number will be listed as “STATION”. To change this to a new number, enter stat= 3 digit number the subscriber needs. >ex;act