User:Dr.Manali/sandbox

STEPS IN THE FABRICATION OF COMPLETE DENTURE
 * 1)  Diagnosis and treatment planning.
 * 2)  Pouring of diagnostic cast using Dental plaster.
 * 3)  Treatment Plan.
 * 4) Pre-Prosthetic Surgery.(If required)
 * 5)  Making the Primary Impression using stock tray
 * 6)  Pouring the Primary Cast
 * 7)  Fabrication of special tray/individual tray/custom tray.
 * 8)  Border moulding with green stick.
 * 9)  Scrapping out the wax spacer from the special tray.
 * 10)  Providing Relief holes.
 * 11)  Making secondary impression (usually with Zinc oxide Eugenol)
 * 12)  Beading and Boxing.
 * 13)  Pouring the Master cast with dental stone.
 * 14)  Fabricating Temporary denture base or Base plate adaptation
 * 15)  Fabricating occlusal rim.
 * 16)  Recording jaw relation
 * 17)  Selection of teeth
 * 18)  Articulation
 * 19)  Teeth setting
 * 20)  Try in or Trial
 * 21)  Acrylization
 * 22)  Denture insertion
 * 23)  Post-insertion instruction
 * 24)  Recall and Check up
 * 25)  Periodic check up after every 6 months.