User:Dtyndall

Name: Dan Tyndall
I am a graduate student at the University of Utah. My past research has included:


 * Research on terrestrial gamma ray flashes and thier connection to lighting.


 * Research on the seasonal variations of ozone concentrations in various cities in Florida.

My current research includes:


 * Evaluation of the Real Time Mesoscale Analysis.


 * Setting up the UULES to be run on a parallel computer to simulate the atmosphere over the Great Salt Lake.

My department's homepage can be found here.

=Horizontal Convective Rolls=

Horizontal convective rolls, or horizontal roll vortices, are long rolls of counter-rotating air that are oriented approximately parallel to the ground in the planetary boundary layer. Although horizontal convective rolls have been clearly seen in satellite photographs of cloud streets for the last 30 years, their development is poorly understood due to a lack of observational data. Research has shown these eddies to be significant to the vertical transport of momentum, heat, moisture, and air pollutants within the boundary layer.

Characteristics
Horizontal convective rolls are counter-rotating vortex rolls that are nearly aligned with the mean wind of the convective boundary layer. Early theory on the features predict that the vortices may be aligned up to 30° to the left for stable environments, 18° to the left for neutral environments, and nearly parallel to the mean wind for unstable environments. This theory has been supported by aircraft observations from several field experiments.

The depth of a vortex is usually the depth of the boundary layer, which is generally on the order of 1-2 km. A vortex pair usually has a lateral to vertical dimension ratio of 3:1. Experimental studies have shown that the aspect ratio (a ratio of roll wavelength to boundary layer depth) has been found to vary between 2.2:1 and 6.5:1, with an average aspect ratio of 5.7:1. However, in some situations, the aspect ratio may be as large as 10:1. Large aspect ratios for rolls are believed to be caused by non-linear interactions at small convective scales, which are not predicted by theoretical calculations. The lifetime of a convective roll can last from 1 to 72 hours.

If the environmental air is near saturation, condensation may occur in updrafts produced from the vortex rotation. The sinking motion produced between alternating pairs of rolls, combined with the updrafts, will produce cloud streets. Typical updraft and downdraft speeds are usually less than 1 m/s. Hand gliders often use the updrafts produced by the rolls to gain altitude while flying.

Development and Required Environmental Conditions
The exact process that leads to the formation of horizontal convective rolls is not well understood, but most formation theories involve a combination of thermal or convective instability and dynamic instability. In thermal instabilities, turbulent energy that forms the rolls is produced from buoyancy. For this condition to be satisfied, a moderate surface heat flux is necessary to produce a slightly unstable environment; however, too much heat flux will cause the environment to be too unstable, and will lead to cellular, instead of roll convection.

Turbulent energy derived from dynamic instabilities is produced from wind shear energy. Dynamic conditions favorable for roll development generally have high speed shear, and very little directional shear. Low speed shear environments generally produce cellular convection. It has been suggested that dynamic instability requires an inflection point in the cross roll wind speed profile—that is, the wind speed profile is curved, reaching a maxima within the boundary layer. Although inflection points are common in many wind profiles of convective roll events, some events have been observed lacking inflection points, suggesting that this is not a requirement for roll convection.

The combination of convective and dynamic instability can be quantified in the ratio $$z_i/L$$, where $$z_i$$ is the depth of the boundary layer and $$L$$ is the Monin-Obukhov length. In the case of roll convection, the Monin-Obukhov length is the height at which turbulent energy production from buoyancy dominates that produced from wind shear. Roll convection is typically observed for $$z_i/L$$ values that are approximately greater than -5 and approximately less than -25. These conditions are most frequently observed in cold air outbreaks, and produce the combination of necessary dynamic and convective instabilities that produce roll convection. Roll convection is more frequently observed over water surfaces than land surfaces, due to the interactions of orography making the convection less distinct.