User:Isaacd12/sandbox

Scope:
HP Indigo 7000 Digital Press, HP Indigo 7500 Digital Press, HP Indigo W7200 Digital Press, HP Indigo W7250 Digital Press, HP Indigo WS6000 Digital Press, HP Indigo WS6600 Digital Press

Overview
The greasing and lubrication system (GLS) pump has a number of improved features over the previous pump:

●          No splashing

●          No grease chunks

●          Drive gear lubrication

●          GDU lubrication

●          Easy cartridge replacement

●          Resistant to imaging oil

This article describes how to install and service the GLS pump.

Parts list
0960–3792 — STAR CONTROL TIME/IMPULSE MODE 9-30VDC

Replacing the GLS pump

 * 1) Turn off the press.

To Remove the old GLS pump:

 * 1) Open the holding clamp and detach it from the pump.
 * 2) Pull the hose out from the top of the pump.


 * 1) Detach the hose from its connector in the press
 * 2) Remove dried grease or dirt from the hose connection and from the hole right next to the hose (remove the Phillips screw

Install the new pump and cartridge:

 * 1) Attach the pump drive to the cartridge. Make sure that the ring connector is in place, as shown in the figure below.