User:Kspokas/sandbox

Coulomb stress transfer is the process of stress changes to surrounding material caused by local discrete deformation events. Using mapped displacements of the Earth’s surface during earthquakes, computed Coulomb stress changes have suggested that stress relieved during an earthquake does not only dissipate, but can also move up and down fault segments, concentrating and promoting subsequent tremors. Importantly, Coulomb stress changes have been applied to earthquake-forecasting models that have been used to assess potential hazards related to earthquake activity.

Coulomb Stress Change
The Coulomb failure criterion requires that the Coulomb stress exceeds a value defined by the shear stress τB, normal stress σB, pore pressure p, and coefficient of friction μ of a failure plane, such that σf = τB - μ(σB – p). It is also often assumed that changes in pore fluid pressure induced by in changes stress are proportional to the normal stress change across the fault plane. These effects are incorporated into an effective coefficient of friction μ’, such that Δσf = ΔτB - μ’(ΔσB). This simplification allows for the calculation of Coulomb stress changes on a fault plane to be independent of the regional stress field but instead depends on the fault geometry, sense of slip, and coefficient of friction.

The significance of the Coulomb stress changes was discovered when mapped displacements of neighbouring fault movements were used to calculate Coulomb stress changes along faults. Results revealed that the stress relieved on faults during earthquakes did not simply dissipate, but also moved up and down fault segments. Moreover, mapped lobes of increased and decreased Coulomb stress around local faults exhibited increased and decreased rates of seismicity respectively shortly after neighboring earthquakes, but eventually return to their background rate over time.

Earthquake Stress Triggering
Stress triggering describes the responsive rupturing of faults from increases in Coulomb stress caused by exogenous deformation events. Although neighbouring displacements often yield small magnitude stress changes, areas of disturbed Coulomb stress states have been successfully used to explain the spatial distribution of stress triggered aftershock seismicity.

On June 28th, 1992, a M7.2 earthquake that struck near Landers, California was followed by the M6.5 Big Bear foreshock earthquake 40km away. Calculated Coulomb stress changes from both of these earthquakes showed a westward lobe of 2.1-2.9 bars of increased Coulomb stress to have resulted from the displacement associated with both earthquakes. Of the roughly 20,000 aftershocks that occurred 25 days after June 28th within a 5km radius, more than 75% occurred in areas where Coulomb stress had increased and less than 25% occurred in areas where Coulomb stress had dropped

Another successful case study of earthquake prediction occurred along Turkey’s North Anatolian fault system. From 1939 to 1999, the Anatolian fault system had witnessed ten earthquakes of M6.6 or greater. The evolution of the Coulomb stress changes along the North Anatolian fault as a result of these earthquakes showed that 11 of the 13 ruptures occurred in areas of increased Coulomb stress caused by a previous rupture.

Earthquake Prediction
Although no official Coulomb stress transfer prediction model is being used by government agencies, geologic surveys often analyze earthquake threats using Coulomb stress theory. As an example, the last of the previous thirteen earthquakes along Turkey’s North Anatolian Fault, near the town of Duzce, was successfully predicted by local geologists before the rupture occurred. This allowed for engineers to evacuate unstable structures and limit significant damage. Scientists estimate that the probability of another earthquake along the Anatolian fault system is 62% over the next 30 years and will be located threateningly close to Istanbul.