User:Sukelaser5

Notice when using CO2 laser engraving cutting machine 1. First, to check the voltage, the standard voltage of Chinese laser machine is AC220v 50hz. but transformer can be installed inside of laser machine. so, AC110v is also ok. 2. After connecting and before working, to check the laser tube, when the water is fully filled to laser tube, then it can work. otherwise, there will no laser light generate. 3. CO2 laser tube has 40w, 60w, 80w, 100w,130w, 150w. and Reci laser tube has W2 W4 W6, W2 (80-100w), W4(120-135W), W6 (150-175w). When laser power is less than 100w, water pump is good enough to keep laser tube cool.. But CW3000 chiller can replace the water pump. Chiller is more beautiful than water pump, but same application. 100W and higher, the industrial chiller is needed. CW5000 and CW5200 are ok. CW5200.

4. When working, to protect the laser tube well for long time, it is better to set laser power less 100%. For example, if the laser power is 100w, if not necessary, you can set the laser power of 80%. Then the working laser power is 80w.

5. If you only engraving, 60w is ok, even 40w. 6. If only cut fabric, 1 layer and 2 layers, 60w is ok. If 3 layers, 80w is good enough. Also as the Item 4 said, you can choose higher laser power, such as 100w, 130w, through set the laser power (%).

For more item to be noted, I will add in following days. If any question, welcome to contact me. My name: Wendy MSN: sukelaser05@hotmail.com Skype: sukelaser5 www.sukelaser.com