User:Sushhere/Sandbox

= Location of events.raw file in Tianocore =

Follow the below steps so as to make sure that the events.raw goes to the USB flash drive always. This is because there have been few instances where the events.raw gets written onto the floppy, this happens when you plug in the USB stick containing the Ultraboot components after booting to Tianocore using a floppy.


 * There won’t be any problem if we boot off with only the USB drive. In this case the events.raw gets written into the flash drive even if there are multiple drives present in your system.


 * While using a floppy to boot off Tianocore, we have to make sure that both the floppy as well as the flash drive (containing the spar Ultraboot components) are plugged in during power on. In this case, the events.raw will go to the largest drive that is the USB stick in this case.


 * In addition to this we could always use an empty events.raw file in the USB drive to make sure events.raw goes to the flash drive, before running Ultraboot. I have tried with this procedure and it works perfectly even if I plug in the flash drive after I am in the EFI shell prompt.