User:Vercingetorix2112/Ring strain

The draft of the article is below. I find it more convenient to use the same heading format as original article, so the initial format has been erased. Some of the headings and subheading have been renamed slightly, and an additional heading has been added.

= Ring strain =

Introduction
(Copied material starts here)

In organic chemistry, ring strain is a type of instability that exists when bonds in a molecule form angles that are abnormal. Strain is most commonly discussed for small rings such as cyclopropanes and cyclobutanes, whose internal angles are substantially smaller than the idealized value of approximately 109°. Because of their high strain, the heat of combustion for these small rings is elevated.

Ring strain results from a combination of angle strain, conformational strain or Pitzer strain (torsional eclipsing interactions), and transannular strain, also known as van der Waals strain or Prelog strain. The simplest examples of angle strain are small cycloalkanes such as cyclopropane and cyclobutane.

(Copied material ends here, our own material starts here)

Ring strain energy can be attributed to the energy required for the distortion of bond and bond angles in order to close a ring.

(added by Ross) Ring strain energy is believed to be the cause of accelerated rates in altering ring reactions. Its interactions with traditional bond energies change the enthalpies of compounds effecting the kinetics and thermodynamics of ring strain reactions.

History
(heading added by Ross)

Ring strain theory was first developed by German chemist Adolf von Bayer in 1890. Previously, the only bonds believed to exist were torsional and steric; however, Bayer's theory became based on the interactions between the two strains.

Bayer's theory was based on the assumption that ringed compounds were flat. Later, around the same time, Hermann Sachse formed his postulation that compound rings were not flat and potentially existed in a "chair" formation. Ernst Mohr later combined the two theories to explain the stability of six-membered rings and their frequency in nature, as well as the energy levels of other ring structures.

Alkanes
(Copied material starts here)

In alkanes, optimum overlap of atomic orbitals is achieved at 109.5°. The most common cyclic compounds have five or six carbons in their ring. Adolf von Baeyer received a Nobel Prize in 1905 for the discovery of the Baeyer strain theory, which was an explanation of the relative stabilities of cyclic molecules in 1885.

Angle strain occurs when bond angles deviate from the ideal bond angles to achieve maximum bond strength in a specific chemical conformation. Angle strain typically affects cyclic molecules, which lack the flexibility of acyclic molecules.

Angle strain destabilizes a molecule, as manifested in higher reactivity and elevated heat of combustion. Maximum bond strength results from effective overlap of atomic orbitals in a chemical bond. A quantitative measure for angle strain is strain energy. Angle strain and torsional strain combine to create ring strain that affects cyclic molecules.



Normalized energies that allow comparison of ring strains are obtained by measuring per methylene group (CH2) of the molar heat of combustion in the cycloalkanes.


 * ΔHcombustion per CH2 − 658.6 kJ = strain per CH2

The value 658.6 kJ per mole is obtained from an unstrained long-chain alkane. (Copied material ends here, our own material starts here)

Cycloalkanes generally have less ring strain than cycloalkenes, which is seen when comparing cyclopropane and cyclopropene.

Alkenes
(Copied material starts here)

Cyclic alkenes are subject to strain resulting from distortion of the sp2-hybridized carbon centers. Illustrative is C60 where the carbon centres are pyramidalized. This distortion enhances the reactivity of this molecule. Angle strain also is the basis of Bredt's rule which dictates that bridgehead carbon centers are not incorporated in alkenes because the resulting alkene would be subject to extreme angle strain. (Copied material ends here, our own material starts here)

Small trans-cycloalkenes have so much ring strain they cannot exist for extended periods of time. For instance, the smallest trans-cycloalkane that has been isolated is trans-cyclooctene. Trans-cycloheptene has been detected via spectrophotometry for minute time periods, and trans-cyclohexene is thought to be an intermediate in some reactions. No smaller trans-cycloalkenes are known. On the contrary, while small cis-cycloalkenes do have ring strain, they have much less ring strain than trans-cycloalkenes.

In general, the increased levels of unsaturation in alkenes leads to higher ring strain. Increasing unsaturation leads to greater ring strain in cyclopropene. Therefore, cyclopropene is an alkene that has the most ring strain between the two mentioned. The differing hybridizations and geometries between cyclopropene and cyclopropane contribute to the increased ring strain. Cyclopropene also has an increased angle strain, which also contributes to the greater ring strain. However, this trend does not always work for every alkane and alkene.

Torsional Strain (Pitzer Strain)
(This entire heading is written by us)

In some molecules, torsional strain can contribute to ring strain in addition to angle strain. One example of such a molecule is cyclopropane. Cyclopropane's carbon-carbon bonds form angles of 60°, far from the preferred angle of 109.5° angle in alkanes, so angle strain contributes most to cyclopropane's ring strain. However, as shown in the Newman projection of the molecule, the hydrogen atoms are eclipsed, causing some torsional strain as well.

Examples
(copied material starts here)

In cycloalkanes, each carbon is bonded nonpolar covalently to two carbons and two hydrogen. The carbons have sp3 hybridization and should have ideal bond angles of 109.5°. Due to the limitations of cyclic structure, however, the ideal angle is only achieved in a six carbon ring — cyclohexane in chair conformation. For other cycloalkanes, the bond angles deviate from ideal.

Molecules with a high amount of ring strain consist of three, four, and some five-membered rings, including: cyclopropanes, cyclopropenes, cyclobutanes, cyclobutenes, [1,1,1]propellanes, [2,2,2]propellanes, epoxides, aziridines, cyclopentenes, and norbornenes. These molecules have bond angles between ring atoms which are more acute than the optimal tetrahedral (109.5°) and trigonal planar (120°) bond angles required by their respective sp3 and sp2 bonds. Because of the smaller bond angles, the bonds have higher energy and adopt more p-character to reduce the energy of the bonds. In addition, the ring structures of cyclopropanes/enes and cyclclobutanes/enes offer very little conformational flexibility. Thus, the substituents of ring atoms exist in an eclipsed conformation in cyclopropanes and between gauche and eclipsed in cyclobutanes, contributing to higher ring strain energy in the form of Van der Waals repulsion.


 * cyclopropane, C3H6 — the C-C-C bond angles are 60° whereas tetrahedral 109.5° bond angles are expected. The intense angle strain leads to nonlinear orbital overlap of its sp3 orbitals. Because of the bond's instability, cyclopropane is more reactive than other alkanes. Since any three points make a plane and cyclopropane has only three carbons, cyclopropane is planar. The H-C-H bond angle is 115° whereas 106° is expected as in the CH2 groups of propane.

(Copied material ends here, our own material starts here)

Cyclopropane has a lesser amount of ring strain since it has the least amount of unsaturation; as a result, increasing the amount of unsaturation leads to greater ring strain. For example, cyclopropene has a greater amount of ring strain than cyclopropane because it has more unsaturation.

Applications
(Copied material starts here)

The potential energy and unique bonding structure contained in the bonds of molecules with ring strain can be used to drive reactions in organic synthesis. Examples of such reactions are Ring opening metathesis polymerisation, photo-induced ring opening of cyclobutenes, and nucleophilic ring-opening of epoxides and aziridines.

(Copied material ends here, our own material starts here)

Increased potential energy from ring strain also can be used to increase the energy released by explosives or increase their shock sensitivity. For example, the shock sensitivity of the explosive 1,3,3-Trinitroazetidine could partially or primarily explained by its ring strain.