User:Yassarvy


 * 1) powermt check_registration


 * 1) emcpreg -install  ( to install license)


 * 1) powermt save ( to save any changes)

If you see errors on the paths, check for HBA link errors. clear the errors on the PP display and observe again.

You may also run emcgrabs on the host, generate HEAT report, make sure HBA BIOS/firmware/drivers are not in red zones, yellow is OK.

Is it that a path for all the luns are showing as dead or for a single lun ? Does this server has any luns connected from Netapp – If no active storage connected from Netapp, are all the netapp paths cleaned up ? Moreover, is Multipathing properly enabled and are the I/Os getting load balanced at host level ?

Is it that a path for all the luns are showing as dead or for a single lun ? Does this server has any luns connected from Netapp – If no active storage connected from Netapp, are all the netapp paths cleaned up ? Moreover, is Multipathing properly enabled and are the I/Os getting load balanced at host level ?