User:Yeapfatman

Note: Super Torque 3 mm, 4,5 mm and 5 mm timing bars can be manufactured on request. TOP DRIVE® HTD 3 mm and 5 mm timing bars can be manufactured on request.

How to order Designation Bestell bei spiel Identificacion PIA T5 / 16 Belt width - Largeur courroie Riemen Breite - Anchura correa (mm) Pitch - Pas - Teilung - Paso Product prefix - Indicatif du produit Artikel Gruppe - Código

SER-SIT® TAPER LOCK BUSHING SER-SIT® taper lock bush is designed to give the following: 1) perfect assembly; 2) rapid dismantling of the pulley and other transmission equipment; 3) no special tools requirement except hexagonal key. The large range of finished bores available ensures that an immediate assembly can be made thus avoiding costly factory down-time. The bushes are machined with keyways in accordance with UNI and DIN specifications. This is in addition to clamping screws which, in many cases, are sufficient to meet the required torque. Fastening by SER-SIT® bushes allows the removal of any clearance between hub and bore so that fretting corrosion is positively eliminated. SER-SIT® bushes are interchangeable with all similar types sold throughout the world.

Assembly and dismantling of SER-SIT® conical bushing • Before fitting the bushing, carefully clean the bore and conical parts. • Fit the bushing into the pulley, taking care to let the threaded half-holes of the pulley coincide with the unthreaded holes of the bushing. • Hand tighten the screws. • Fit the pulley to the hub after carefully cleaning it. Position it and tighten the screws alternately. • Dismantling: remove screws and replace one screw in the jacking hole provided and tighten until hub is released. NOTE - Ensure that the key does not bottom in the keyway. Clearance in recommended in the keyway bottom.