User talk:Sam38

crank first

bearings A always in the engine block

insert bearing A from inside of engine block

then oil seal from outside

Main bearing B needs to be located on shaft first

magneto casing needs oil seal 2 and main bearing 2 before crankshaft is inserted

when inserting piston, crank must be at top

turn to bottom to fasten bolts


 * 1) Insert Main bearing A into engine block from the inside
 * 2) Fit Main bearing B on Crankshaft
 * 3) Insert Crank Shaft Oil seal 2 into Magneto Plate Cover
 * 4) Lay gasket E into Magneto plate cover
 * 5) Insert Crankshaft into engine block
 * 6) Insert Piston From top into engine block
 * 7) lay needle bearings into connecting rod and connecting rod end cap
 * 8) Place connecting rod end cap onto crankshaft and fasten with bolts
 * 9) locate magneto plate cover to engine block with bolts
 * 10) Lay Woodruff key into key way
 * 11) connect flywheel
 * 12) Fasten with 15mm nut
 * 13) Lay gasket A into engine block
 * 14) insert oil seal 1
 * 15) connect crank case pressed side cover plate with 6mm bolts
 * 16) Lay Gasket D on engine Block
 * 17) connect head cover with bolts
 * 18) Place Gasket B on Reed valve
 * 19) connect reed Valve and carburetor with 10mm bolts
 * 20) Lay Gasket C on Engine Block
 * 21) connect reed valve to engine block with 6mm bolts
 * 22) insert spark plug
 * 23) Lay gasket F onto Exhaust manifold
 * 24) Connect with 6mm bolts
 * 1) Lay gasket A into engine block
 * 2) insert oil seal 1
 * 3) connect crank case pressed side cover plate with 6mm bolts
 * 4) Lay Gasket D on engine Block
 * 5) connect head cover with bolts
 * 6) Place Gasket B on Reed valve
 * 7) connect reed Valve and carburetor with 10mm bolts
 * 8) Lay Gasket C on Engine Block
 * 9) connect reed valve to engine block with 6mm bolts
 * 10) insert spark plug
 * 11) Lay gasket F onto Exhaust manifold
 * 12) Connect with 6mm bolts
 * 1) connect reed Valve and carburetor with 10mm bolts
 * 2) Lay Gasket C on Engine Block
 * 3) connect reed valve to engine block with 6mm bolts
 * 4) insert spark plug
 * 5) Lay gasket F onto Exhaust manifold
 * 6) Connect with 6mm bolts
 * 1) insert spark plug
 * 2) Lay gasket F onto Exhaust manifold
 * 3) Connect with 6mm bolts
 * 1) Lay gasket F onto Exhaust manifold
 * 2) Connect with 6mm bolts
 * 1) Connect with 6mm bolts