User talk:Varia do

Just posted two pic's showing where to cut etch to convert a MICOR 800 MHz PA to 927 MHz. The results will provide 60-70 watts out for 1.5-2 watts input with +12vdc on the power control line. The pic's are of the controlled stage and the predriver stage. Recommend using a drimbal like tool to cut a gap in the etch starting at the point indicated in the diagram and finish approximately where shown. Stop when you reach 60-70 watts out. If you go too far you can add silver paint similar to the syntorx or maxtrac vco modes. Recommend adjusting the power control line for about 50-60 watts which was about 6vdc on my amp. Final current at 12vdc was 20ish amps not very efficient. Also, when I finished at 927 MHz, at 902 the power output was 80 watts. All measurements were with the isolator and LPF bypassed. This is a brut force method and some tweaking to the balanced amps mite help however, 60 watts came up ezy so I left the balanced amps for another day or someone else to play with. Any questions or findings please email.

Welcome!
Hello, Varia do, and welcome to Wikipedia! Thank you for your contributions. I hope you like the place and decide to stay. Here are a few links to pages you might find helpful: Please remember to sign your messages on talk pages by typing four tildes ( ~ ); this will automatically insert your username and the date. If you need help, check out Questions, ask me on my talk page, or ask your question on this page and then place  before the question. Again, welcome! --Animalparty-- (talk) 17:16, 12 April 2014 (UTC)
 * Getting started
 * Introduction to Wikipedia
 * The five pillars of Wikipedia
 * How to edit a page and How to develop articles
 * How to create your first article
 * Simplified Manual of Style

WikiProject Lepidoptera
Since you're interested in moths, be sure to check out WikiProject Lepidoptera for more ways to contribute and improve articles.