9×18mm Makarov

The 9×18mm Makarov (designated 9mm Makarov by the C.I.P. and often called 9×18mm PM) is a pistol and submachine gun cartridge developed in the former USSR. During the latter half of the 20th century, it was a standard military pistol cartridge of the Soviet Union and the Eastern Bloc, analogous to the 9×19mm Parabellum in NATO and Western Bloc military use.

History
During the Second World War and the early Cold War, the 7.62×25mm Tokarev was the standard automatic pistol round for the Soviet Union and its satellites in Eastern Europe. This ammunition is still in use by many of these countries today. During the war, the Red Army had found a few shortcomings in its 7.62 mm TT-33 pistol, one of which was a tendency to inadvertently drop its magazine while in operation. The army wanted something that was lighter, with a heel release instead of a button and different ammunition. A direct blowback design was chosen for the pistol's operation, since it would be quick and cheap to manufacture, as well as accurate, due to the fixed-barrel design allowed by direct blowback operation.

The 9×18mm round was designed by Boris V. Semin in 1946, and was intended to be a relatively powerful round with modest bolt thrust that could function safely in a simple or direct blowback pistol. It was based on the 9×18mm Ultra cartridge which was developed in 1936 by Gustav Genschow & Co. for the German Luftwaffe, as a more powerful alternative to the 9×17mm used in the Walther PP, also a simple blowback design pistol. Nikolay Fyodorovich Makarov went on to design the Makarov PM pistol around the 9×18mm round in 1947. In 1951 both the Makarov pistol and the round were accepted by the Soviet Army, hence the round became commonly known thereafter as the Makarov as well (it is not its official designation).

Calibers in the USSR were measured between the lands in the rifling and not the grooves. As such, 9×18mm Makarov ammunition uses a larger diameter bullet than other common 9 mm rounds, measuring 9.27 mm (0.365 in), compared with 9.017 mm (0.355 in) for 9×19mm Parabellum. After its introduction in 1951, the 9×18mm Makarov round spread throughout the militaries of Eastern Bloc nations.

Cartridge dimensions
The 9×18mm Makarov has 0.83 ml (12.8 grains of H2O, also known as water) cartridge case capacity.



'''9×18mm Makarov maximum C.I.P. cartridge dimensions. All sizes in millimeters (mm).'''

The common rifling twist rate for this cartridge is 1 in 240 mm (9.45 in), 4 grooves, ø lands = 9.00 mm, ø grooves = 9.27 mm, land width = 4.50 mm and the primer type is small pistol.

According to the official C.I.P. (Commission Internationale Permanente Pour L'Epreuve Des Armes à Feu Portatives) rulings the 9×18mm Makarov case can handle up to 160.00 MPa piezo pressure. In C.I.P. regulated countries every pistol cartridge combo must be proofed at 130% of this maximum C.I.P. pressure to certify for sale to consumers.

The 9×18mm Makarov is ballistically inferior to the 9×19mm Parabellum cartridge. While there are no official SAAMI pressure specifications for the 9×18mm Makarov cartridge, tests indicate that surplus ammunition develop pressures in the lower 20,000 psi range, which is significantly less than the 35,000 psi or more generated by 9×19mm Parabellum (+P) loads. As such it is designed to be used in low-powered blowback semiautomatics, much like the .380 ACP cartridge, rather than locked-breech designs encountered, but not always required, for higher pressure cartridges like the 9×19mm Parabellum.

Basic specifications of 21st century Russian service loads
The 9×18mm Makarov rounds in use with the Armed Forces of the Russian Federation are designed for pistols and submachine guns. In 2003, there were several variants of 9×18mm Makarov produced for various purposes. All used clad metal as case material.

The 57-N-181S cartridge is loaded with a steel-core bullet and is designed to kill personnel at a range of up to 50 m. The bullet has a clad metal envelope totally covering the core. The bullet's nose is spherical with no distinguishing colour of the tip. It can penetrate a 1.3 mm thick St3 steel plate or a 5 mm ordinary steel plate at 20 m.

The RG028 cartridge is loaded with an enhanced penetration bullet and is designed to kill personnel wearing body armour. The bullet has a core of hardened steel.

The SP-7 cartridge is loaded with an enhanced stopping effect half plastic and half lead core jacketed hollow point bullet and is designed to defeat live targets. The bullet has a black tip.

The SP-8 cartridge is loaded with a lightweight half plastic and half lead core low-penetration jacketed hollow point bullet and is designed to engage personnel.

The 7N25 is a high-velocity cartridge loaded with a steel core bullet. It can penetrate a 5 mm thick St3 steel plate at 10 m.


 * R50 at 25 m means the closest 50 percent of the shot group will all be within a circle of the mentioned diameter at 25 m.

Pistols

 * Makarov PM
 * Stechkin APS
 * MP-448 Skyph
 * ČZ vz. 82
 * FEG PA-63, SMC-918, R-61, RK-59
 * P-83 Wanad
 * P-64 pistol
 * R-92
 * OTs-01 Stechkin (RSA)
 * OTs-27
 * OTs-33
 * Fort 12
 * Grand Power P9M
 * ZVI KEVIN M
 * SilencerCo Maxim 9

Submachine guns and machine pistols

 * Škorpion vz. 65 and vz. 82
 * PM-63 RAK
 * PM-84 Glauberyt
 * PP-90 Penal
 * PP-91 KEDR
 * PP-93
 * OTs-02 Kiparis
 * OTs-33 Pernach
 * PP-19 Bizon
 * Arsenal Shipka
 * Borz, used by Chechen Republic of Ichkeria during the First Chechen War

Synonyms

 * 9mm Makarov
 * 9×18mm
 * 9×18mm PM
 * 9mm Mak
 * 9×18mm Soviet