Phase 3 Eclipse

The Phase 3 Eclipse is an American ultralight aircraft that was designed by Bruce Emmons and produced by Phase 3 Aircraft. The aircraft was supplied as a kit for amateur construction.

Design and development
The aircraft was designed to comply with the US FAR 103 Ultralight Vehicles rules, including the category's maximum empty weight of 254 lb. The aircraft has a standard empty weight of 165 lb. It features a cantilever high-wing, inverted V-tail, a single-seat, open cockpit, tricycle landing gear and a single engine in pusher configuration.

The aircraft is made from bolted-together aluminum tubing, with the flying surfaces covered in double surface Dacron sailcloth. Its elliptical planform 32.2 ft span wing it mounted using several cabane struts and produces a 15:1 glide ratio. The pilot sits on an open-air seat, without a windshield. The control system is unusual in that roll control is by cable-actuated wing warping. All three landing gear wheels have suspension and the nosewheel is steerable. The 25 hp KFM 107 powerplant is mounted behind the pilot's seat, with the propeller in between the upper and lower tailboom tubes. The design was proof-tested to +9/-9 g. The aircraft exhibits good stability in all axes in flight and can be quickly dismantled for storage or ground transport. The wing is removed with three bolts.

The design was introduced just before the ultralight market in the US became saturated in 1984, as such it such never became a commercial success. Only a small number were completed.