Raven Explorer I

The Raven Explorer I is an American autogyro that was designed and produced by Raven Rotorcraft of Boulder Colorado and later El Prado, New Mexico, introduced in the 1990s. Now out of production, when it was available the aircraft was supplied as a kit, for amateur construction.

The Explorer I is no longer available as the company has moved to develop the two-seat Raven Rotor-Plane.

Design and development
The Explorer I was designed as a low-cost utilitarian autogyro. It complies with the US FAR 103 Ultralight Vehicles rules, including the category's maximum empty weight of 254 lb. The aircraft has a standard empty weight of 254 lb. It features a single main rotor, a single-seat open cockpit without a windshield and conventional landing gear. A cockpit fairing was a factory option. The acceptable power range is 45 to 65 hp and the standard engine used is the twin cylinder, air-cooled, two-stroke, single-ignition 45 hp 2si 460 engine in tractor configuration. The cabin width is 28 in.

The aircraft fuselage is made from a combination of welded 4130 steel tube and bolted-together aluminum tubing. Its two-bladed rotor has a diameter of 23 ft. The aircraft has a typical empty weight of 254 lb and a gross weight of 564 lb, giving a useful load of 310 lb. With full fuel of 5 u.s.gal the payload for the pilot and baggage is 280 lb.

The standard day, sea level, no wind, take off with a 45 hp engine is 250 ft and the landing roll is 50 ft.

The manufacturer estimated the construction time from the supplied kit as 100 hours.